Installation instructions for Airtac air source processor
1. There are two ways of filter drainage: pressure difference drainage and manual drainage. When draining manually, it must be drained before the water level reaches the level below the filter element.
2. When adjusting the pressure, please pull up and then rotate the knob before turning it. Press down the knob to position it. Turn the knob to the right to increase the outlet pressure, and to the left to decrease the outlet pressure. When adjusting the pressure, it should be adjusted gradually and evenly to the required pressure value, and should not be adjusted in one step.
3. How to use the oil feeder: The oil feeder uses JIS K2213 oil (ISO Vg32 or equivalent oil). Please do not fill the cup more than 80% full. The number 0 is the smallest amount of oil, and 9 is the largest amount of oil. It cannot be rotated from the 9-0 position and must be rotated clockwise.
