What are the two types of vacuum generating components? What's the difference between the two?

What do the codes of DD motors represent?

How are cartons formed? Analysis on the basic principles of carton unpacking machine

Introduction to Teflon and Bakelite

Detailed explanation of the design of a ratchet intermittent motion mechanism!

What is a nitrogen gas spring? Can it be used in non-standard designs?

How to design a screw transplanting module?

Design of single-motor driven conjugate cam dual-axis linear reciprocating manipulator

How to design the tray moving mechanism? How to calculate the parameters of vacuum suction cup?

Selection of pneumatic fingers in carrier plate transfer mechanism

Structural design and precautions of screw lifting mechanism

How do mechanical engineers design a soft pack power battery module assembly line?

Commonly used heat treatments for non-standard designs - quenching

How to create a dynamic explosion diagram in SolidWorks? You'll learn it in no time! !

How do mechanical engineers design automatic inspection equipment for battery cells?

SOLIDWORKS software advanced fits—width fits

If a single-axis or two-axis cylinder is used, it must be equipped with guide rails to guide and withstand bending moments.

Three-axis material transfer manipulator mini cylinder explanation

What is tempering? What are the types? What effect can be achieved?

Introduction to commonly used feeding methods for chip resistor screening equipment

Two-axis cam material transfer manipulator

What are the application fields of stepper motors? When is it necessary to wear a brake device?

A mechanical design table covering all mechanical design formulas

Vacuum cam picking manipulator

What components does a 3D printer consist of? What issues need to be paid attention to when designing?

What are the known conditions required when selecting a synchronous belt?

How to choose a suitable motor based on calculation results?

What are the commonly used metal surface treatments?

Once you understand these 3 points, the design of the roller will not be difficult!

How to design the handrail welding positioner? How to apply and select the rotary clamping cylinder?