The use and maintenance of Airtac air source processor
1. Work The medium should use clean and dry compressed air, and the air in the pipes should be fully blown out to prevent impurities from being brought into the system and causing malfunction of the cylinder and valves
Lubrication is required It is necessary to refill the mist device in the piping system. The recommended lubricating oil is transparent No. 1 oil (ISOVG32);
2. After the system is running normally, the work of the air filter and the mist device must be checked regularly. According to the situation, drain the water (except automatic drainage) and refuel in time;
3. When the cylinder and valve are not used for a long time, pay attention to the minimum operating frequency of 1 time/30 days;
4. It is necessary to frequently check the operation of various pneumatic components and check whether the connection fastening screws are loose? Is there any damage or leakage to the seal of the component?
Dispose of problems promptly;
5. During maintenance, be sure to turn off the air source in advance and remove the compressed air from the piping system. Maintenance work can only be carried out after emptying to prevent accidents
;
6. When components are inspected and reassembled, the parts must be Clean it thoroughly and do not bring impurities into the system.
